English
  • 中文简体
  • English
Home> News>Recent news>Inside and Outside Polishing Machine

Inside and Outside Polishing Machine

From:Zhaoqing second machine tool works Co., Ltd.     Release time:2019-08-20

Overview:The metal inner and outer ring polishing machine is a matching equipment for the metal ring machine. After the ring is welded, the solder joint is polished and smoothed; the metal ring polishing machine can also be used to light the entire surface of the metal ring; the device is a semi-automatic device. More efficient.

Inside and Outside Polishing Machine

The metal inner and outer ring polishing machine is a matching equipment for the metal ring machine. After the ring is welded, the solder joint is polished and smoothed; the metal ring polishing machine can also be used to light the entire surface of the metal ring; the device is a semi-automatic device. More efficient.

Polishing machine basic configuration:

1. A set of mechanical maintenance kits,

2. Each set of product electrical diagram and operating instructions.

More data on metal ring polishing machines. Please contact the marketing department of Sino-German.

Inside and Outside Polishing Machine Instructions:

First, the installation:

Install the exhaust motor, the pole, and the handle of the handwheel that are removed during transportation. Place the machine smoothly and pay attention to the space when processing the large ring.

Second, trial run:

1. The power supply of this machine is three-phase 380V. When wiring, you should select “Shun” as the working status.

2. Turn on the power supply, operate the cylinder valve, check whether the passive wheel slider is flexible, and pay attention to the debris and lubrication at the slider.

Third, the preparation before starting:

1. Adjust the size of the passive wheel by the size of the eye ring. The large ring distance is opened and the small ring is reduced.

2. Adjust the position of the ring support bearing so that the ring is fully supported.

Fourth, the operation steps:

1. Insert the metal ring into the groove of the driving wheel and operate the pneumatic valve so that the inner and outer edges of the metal ring are completely pressed.

2. Operate the reverse switch to the “Shun” position and start the machine for polishing. Polishing force is adjusted by hand up and down.

3. When the metal ring is wide, the polishing wheel can be moved laterally for polishing. After throwing one side, stop, operate the pneumatic valve, take out the turning surface, and complete the operation process.


Message BoardPlease write down your question and we will respond to you within 24 hours.