English
  • 中文简体
  • English
Home> News>Recent news>Introduction to metal cleaning methods

Introduction to metal cleaning methods

From:Zhaoqing second machine tool works Co., Ltd.     Release time:2019-04-15

Overview:Metal Ware Washing Line manufacturers introduces put the clean water into the cleaning tank of the ultrasonic cleaning machine, add a certain proportion of oil removal or wax removal cleaning agent, the liquid level is about two-thirds, set the heating temperature of the ultrasonic cleaning machine, the oil removal is generally 50-65 The degree is preferably as good as 85-100 degrees for wax removal.

Metal Ware Washing Line manufacturers introduces put the clean water into the cleaning tank of the ultrasonic cleaning machine, add a certain proportion of oil removal or wax removal cleaning agent, the liquid level is about two-thirds, set the heating temperature of the ultrasonic cleaning machine, the oil removal is generally 50-65 The degree is preferably as good as 85-100 degrees for wax removal.

2. Then turn on the heating function to heat the water to the preset temperature. If you want to speed up the heating time, you can turn on the ultrasonic function, or use hot water directly. When the temperature reaches the preset temperature, put the product to be cleaned into the cleaning. Put it in the basket or on the hanger, and pay attention to the cleaning solution. Open the ultrasonic cleaning function for cleaning. The cleaning time is usually about 3-10 minutes or depending on the specific conditions of different cleaning products.

3. After cleaning, proceed to the next step, rinse and dry according to product requirements.

4. Cleaning parts processing: When the cleaning parts are in the ultrasonic cleaning tank, no cleaning parts or cleaning parts baskets should be attached to the bottom of the tank for cleaning. The product is preferably 50 mm away from the bottom of the tank.

5, rubber, insulated cleaning parts and non-rigid plastics will absorb ultrasonic energy, improper design of the tool basket, or the workpiece is too heavy and too dense, even if the efficiency of the best ultrasonic cleaning system will be greatly reduced.

6, the type of workpiece, the cleaning agent used, the cleaning amount, the cleaning efficiency and effect, the equipment use site, the machine cost can withstand the range, to determine and choose to use one of automatic, semi-automatic, manual, single-slot, multi-slot cleaning Program. If you want to learn more about Semi-automatized Machine suppliers,you can contact us.


Message BoardPlease write down your question and we will respond to you within 24 hours.